• back

REFeB-bar holding magnet with tappet,
galvanized, insert design

Part No.	Size [mm]					Weight [g]	Holding force² [N]
	D¹	H¹	L¹	d	A³
170372	6	20	8	3	15	5	6
170373	8	20	8	3	15	9	12
170374	10	20	8	4	15	13	24
170375	13	20	8	4	15	22	60
170376	16	20	8	5	15	33	90
170377	20	25	8	6	18	63	135
170378	25	35	10	8	27	138	190
170379	32	40	10	10	32	257	340

Maximum operating temperature: 80° C

¹ Tolerance

The size tolerance can be seen by hovering the mouse over the values in the table above.

² Holding force

The holding forces are ascertained using an even polished plate of ST 37 material with a thickness of 10 mm by the vertical withdrawal of the magnet at room temperature. Small cracks in the magnet material do not affect the holding force. Deviations up to minus 10 % are possible in some instances. The data given relates to minimum values which are normally exceeded.

³ Dimension A

Height H can be reduced by dimension A without loss of holding force if there is no magnetic conducting material at the end of the bar holding magnet.

Download Catalogue
Holding magnets	PDF (2.4MB)

• top
• back