• back

Manual destacker

It is essential to wear safety gloves when working with steel sheet!

Part No.	Description	Size [mm]
		L x B x H
170734-H	with leather belt	60 x 35 x 15
170734-HK	with plastic belt	60 x 35 x 15

Function:

Apart from the form and size of the permanent magnetic system, the holding force exercised by a magnetic adhesive system on a steel sheet also depends on the thickness of the sheet to be attracted. Saturation of the sheet occurs if the thickness of the sheet falls below a certain amount. This causes force lines to pass through the sheet, which may then affect and attract other sheets in the stack. Saturation can be avoided by appropriate selection of the adhesive system's pole spacing. The manual destacker developed by us takes account of these circumstances. It has a multi-pole partition with close-polarity spacing and ensures that only one sheet is lifted from the stack. The total holding force where vertical lifting is concerned is approx. 20 kp. This value fully suffices for lifting sheets with a thickness of up to 2 mm.

Design and delivery form

The manual destacker's close-polarity partitioned permanent magnetic system is arranged in a robust aluminium housing. The housing has two wide eyes on the sides through which a leather belt - or plastic on request - is threaded. We recommend it for destacking sheets with a thickness of up to 2 mm.

Application

The manual destacker is wrapped and held fast over the work glove with the help of the leather belt. The magnetic system lies firmly on the inner hand surface without being a disturbance. In order to lift a sheet from the stack, the hand is laid flat on one corner of the sheet. The sheet is attracted by the magnet and can be easily lifted or pushed over the edge of the stack. The manual destacker is removed from the sheet again without difficulty by bending the hand. The sheet can now be picked up by hand and transported.

Download Catalogue
Holding magnets	PDF (2.4MB)

• top
• back